![]() ![]() I tried using pip to install the utility by my version of python is incompatible with the utility.I only deleted one of two homeassistant AUTOMATIONs because I did not go back and check.My first attempt failed because the curl at Step one had “/apps” before the pipe to python and then I replaced it with “/installedapps” and it worked.I experienced several minutes delay during one rebuild. Wait a few minutes then check the Smartthings app to see if all homeassistant AUTOMATIONs are gone. Repeat 3 and 4 until no homeassistant AUTOMATIONs are reported at Step 3.Ħ. Now delete (one of) the homeassistant AUTOMATION using curlĬurl -X DELETE -header "Authorization: Bearer " ĥ. You will get something like this with one or more apps listed ![]() Get a list of all SmartApps using curl on any processor that has python installed:Ĭurl -header "Authorization: Bearer " | python -m json.tool Test the setup using curl from Step 1 below and deal with network and python issues if any are found.ģ. Verify that python is installed and note the version in case the following does not work for you. I use the Home Assistant IDE and its command lineī. Background: Adam Hughes got us off to a good start back in November with a simple fix as follows: 1. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |